Loading... Please wait...

"Closeout" TM10 Tide Clock Movement for dial/case up to 1/8" thick, with this hand only


Product Description

"Closeout" Make or repair your own TIDE CLOCK with this Quartz tide clock movement from Coastal Tide Clocks. 


  • The TM10 movement is designed to SNAP into the two tabs on the back of some tide clocks or it may be glued.
  • Tide movement dimensions:  2 1/8"w x 2 1/8"h x 5/8"deep
  • Total shaft length 3/8" or 10mm - NOTE: Total shaft length with pin cap installed will add approximately 1/16" to 1/8" in overall shaft length.
  • Maximum dial/case thickness 1/8"
  • Comes with black hand and pin cap for a finished look.
  • Requires one new AA alkaline battery (not included)
  • A  2-3/8 inch hand is included with motor. This is the only hand that will fit this movement.
  •  (Our tide clocks motors use one hand only).
  • Instructions included

NOTE:  If making a new TIDE clock, measure the thickness of your dial to make sure you have enough shaft length to go through the case.
If replacing an existing TIDE clock motor, remove non-working motor and compare your dimensions to our specs to select the correct movement.

Our tide clock motors work best for the Atlantic Ocean and its surrounding waterways due to their semidiurnal tides (2 high and 2 low tides per day).

Click on bulk pricing link below "add to cart" button to see discounts.



Product Reviews

Write Review

This product hasn't received any reviews yet. Be the first to review this product!