Loading... Please wait...

TM7.8 Tide Clock Movement and 3 inch hand for dial/case up to 1/16" thick.

$8.50

Product Description

Make or repair your own TIDE CLOCK with this tide clock movement from Coastal Tide Clocks. 

Specifications:

  • The TM7.8 movement is designed to SNAP into the two tabs on the back of some tide clocks or it may be glued.
  • Tide movement dimensions:  2 1/8"w x 2 1/8"h x 5/8"deep
  • Total shaft length 5/16" - NOTE: Total shaft length with pin cap installed will add approximately 1/16" to 1/8" in overall shaft length.
  • Maximum dial/case thickness 1/16"
  • Comes with black hand and pin cap for a finished look.
  • Requires one new AA alkaline battery (not included)
    • Our tide clocks uses one hand only. Included one 3 inch straight hand which may be cut with household scissors. See tide hands to order different hand if needed. FYI you may order same tide movement without hand then order hand of your choice, see  the "Tide Clock Hands" section.
  • Instructions included

NOTE:  If making a new TIDE clock, measure the thickness of your dial to make sure you have enough shaft length to go through the case.
If replacing an existing TIDE clock motor, remove non-working motor and compare your dimensions to our specs to select the correct movement.

Our tide clock motors work best for the Atlantic Ocean and its surrounding waterways due to their semidiurnal tides (2 high and 2 low tides per day).

Click on bulk pricing link below "add to cart" button to see discounts.

 

 

Product Reviews

Write Review

This product hasn't received any reviews yet. Be the first to review this product!

Quantity: